JN0-363 Tested & Approved JNCIS-SP Study Materials [Q64-Q80]

QUESTION 64
Click the Exhibit button.

You must create a static route on Router-A to the 10.10.5.0/24 network using 10.10.3.2 as the next hop.
Referring to the exhibit, which configuration accomplishes this task?

QUESTION 65
Click the Exhibit button. In the exhibit, all routers are sending routes to Router B

Which routes will be advertised from Router B to Router D?

QUESTION 66
Click the Exhibit button.

Referring to the exhibit, which statement is correct?

QUESTION 67
Referring to the exhibit, what will happen to untagged frames?

QUESTION 68
Click the Exhibit button. In the exhibit, three IPv6 addresses are listed. Which two statements are true? (Choose two.)

QUESTION 69
Click the Exhibit button.

Referring to the exhibit, which two statements are true? (Choose two.)

QUESTION 70
What is the correct order of BGP attributes for active route selection?

QUESTION 71
Which statement is true about GRE encapsulation?

QUESTION 72
You have configured multiple IP-IP tunnels across your network to provide connectivity to remote sites.Which technique is used to help the IP endpoints in your network determine the optimal packet size to send across your tunnels?

QUESTION 73
You are asked to assign interface xe-1/0/5 to a virtual switch. What must be accomplished to complete the configuration?

QUESTION 74
Click the Exhibit button.

You have configured IPv6 over IPv4 tunneling, as shown in the exhibit. However, hosts connected to network 2001:0:0:1::0/64 cannot communicate with hosts on network 2001:0:0:2::0/64. The router R2 has a similar configuration as the R1 router.
How would you solve this problem?

QUESTION 75
Click the Exhibit button.

Which type of route is shown in the exhibit?

QUESTION 76
In your RSVP network you have configured three separate LSPs to the same egress address. You have made no other configuration changes to the forwarding decisions made by the router.Which commands can you use to determine which LSP is being used to forward packets?

QUESTION 77
Click the Exhibit.

Referring to the configuration shown in the exhibit, which statement is true?

QUESTION 78
Which statement is correct about IS-IS?

QUESTION 79
Which new field is added to an IPv6 header as compared lo IPv4?

QUESTION 80
You have been asked to use a convention that allows for auto configuration of interface addresses.
You are not allowed to use DHCPv6. What do you do?