[Q38-Q61] Updated 300-420 Dumps PDF – 300-420 Real Valid Brain Dumps With 210 Questions!

NO.38 An engineer uses Postman and YANG to configure a router with:
OSPF process ID 400
network 192.168.128.128/25 enabled for Area 0
Which get-config reply verifies that the model set was designed correctly?

NO.39 Which design consideration must be made when dual WAN Edge routers are deployed at a branch site?

NO.40 A company with multiple service providers wants to speed up BGP convergence time in the event a failure occurs with their primary link. Which approach achieves this goal and does not impact router CPU utilization?

NO.41 What is an advantage of designing an out-of-band network management solution?

NO.42 Which two techniques improve the application experience in a Cisco SD-WAN design? (Choose two.)

NO.43 In an SD-WAN architecture, which methods are used to bootstrap a vEdge router?

NO.44 In what mode does an LWAPP-enabled access point operate?

NO.45 Refer to the exhibit. Where must an architect plan for route summarization for the topology?

NO.46 What are two benefits of designing an SD-WAN network fabric with direct Internet access implemented at every site? (Choose two.)

NO.47 Which two best practices must be followed when designing an out-of-band management network? (Choose two.)

NO.48 Drag and drop the properties from the left onto the Cisco SD-WAN components that perform them on the right.

NO.49 Which feature is used to optimize WAN bandwidth of IGMP network traffic among WAN Edge routers in the same VPN?

NO.50 What is a benefit of using VRRPv3 as compared to VRRPv2?

NO.51 Drag and drop the descriptions from the left onto the corresponding VPN types on the rights.

NO.52 An engineer is looking for a standards-driven YANG model to manage a multivendor network environment.
Which model must the engineer choose?

NO.53 Drag and drop the descriptions from the left onto the Cisco SD-WAN component they describe on the right.

NO.54 How is internet access provided to a WAN edge router that is connected to a MPLS transport link?

NO.55 Which two statements about VRRP object tracking are true? (Choose two)

NO.56 A network engineer must segregate three interconnected campus networks using IS-IS routing. A two-layer hierarchy must be used to support large routing domains and to avoid more specific routes from each campus network being advertised to other campus network routers automatically. Which two actions does the engineer take to accomplish this segregation? (Choose two.) Designate two IS-IS routers as BDR routers at the edge of each campus, and configure one BDR for all Level 1 routers and one BDR for all Level 2 routers.

NO.57 Drag and drop the characteristics from the left onto the correct telemetry mode on the right.

NO.58 Which two routing protocols allow for unequal cost load balancing? (Choose two.)

NO.59 Drag and drop the model-driven telemetry considerations from the left onto the modes they apply to on the right.

NO.60 Refer to the exhibit.
C0FD9F48 C9ACDC725EA850EC2476EE1E

A network engineer is designing a network for AS100. The design should ensure that all traffic enters AS100 via link 1 unless there is a network failure. In the event of a failure, link 2 should function as the path for incoming traffic. Which solution should the design include?

NO.61 An architect is designing a network that will utilize the spanning tree protocol to ensure a loop-free topology.
The network will support an engineering environment where it is necessary for end users to connect their own network switches for testing purposes. Which feature should the architect include in the design to ensure the spanning tree topology is not affected by these rogue switches?