TAKE Pure Storage FAIS FlashArray-Implementation-Specialist PRACTICE QUESTIONS FOR AMAZING RESULTS [Q68-Q88]

QUESTION 68
An evacuation is already in progress when the Account Team informs the Implementation Engineer that the customer wants to include another data pack to the evacuation. How should the Implementation Engineer proceed with this request?

QUESTION 69
At the completion of an upgrade, what command should the Implementation Engineer run to send phonehome logs?

QUESTION 70
Which Purity command can be used to validate I/O is balanced across initiators?

QUESTION 71
Which command should the Implementation Engineer run to verify that Remote Assist is working properly?

QUESTION 72
What command should the Implementation Engineer run to view NVRAM install and update status?

QUESTION 73
What is the minimum supported capacity requirement for a FlashArray//XL170R5?

QUESTION 74
The Customer’s Implementation Workbook specifies that the SMTP reply is “outlook.microsoft.com:587”. What correction should be made for array initialization to be successful?

QUESTION 75
After rebooting a controller, which command should an Implementation Engineer run to verify all the Purity services have started successfully?

QUESTION 76
A customer needs to have arrays installed and configured with ActiveCluster and ETH replication. The installation document contains 3 IP addresses. How many additional IP addresses are needed?

QUESTION 77
What is the minimum AC voltage required to operate a FlashArray//X20R4 array?

QUESTION 78
A customer has a FlashArray X20R3 with 22/22 data packs in the chassis at 80% space usage and wishes to swap one of the data packs for a 45TB pack. What step needs to be taken to facilitate this consolidation?

QUESTION 79
An Implementation Engineer is onsite to install a new DFM data pack (DP) to CH0.BAY10-CH0.BAY19 of a FlashArray. After adding the drives to the chassis, which command should the Implementation Engineer run to verify if the new DP is in a wide write group?

QUESTION 80
An Implementation Engineer is upgrading a FlashArray//X50R3 to an //X50R4. The array has 10 SAS and 10 DirectFlash modules in the chassis. What type of controller is required to complete the upgrade?

QUESTION 81
An Implementation Engineer has completed a hardware NDU, but after the upgrade, Purity reports a “health not responding” status when running pureadm status.
Before contacting support, which command should the Implementation Engineer run to review a list of possible logged issues?

QUESTION 82
A customer would like to consolidate their SAS shelves and wants to evacuate multiple shelves in parallel. What is a prerequisite for this procedure?

QUESTION 83
Prior to running the puresetup newarray command, which command should an Installation Engineer run on a new install of an //XR4 array?

QUESTION 84
After an Implementation Engineer installs a new FlashArray and runs health checks, they see that Phonehome and Remote Assist are NOT working correctly. Which outbound port needs to be open for all management ports (physical and virtual)?

QUESTION 85
When using FA File, where can the Implementation Engineer manage directories?

QUESTION 86
Before proceeding with a controller upgrade, phonehome logs must be sent. What command will verify that the logs have been sent?

QUESTION 87
An Implementation Engineer is getting ready to install four DFMs into a 16-module efficiency bundle and notices that the new modules are DFMDs while the installed modules are DFMs. What should the Implementation Engineer do to get the array using a 20-module Wide write group?

QUESTION 88
When performing an install on a FlashArray, what step should be taken first?