Latest Success Metrics For Actual NCP-BC Exam (Updated 111 Questions) [Q20-Q42]

QUESTION 20
An organization uses a Recovery Plan to protect a SQL Cluster that relies on Volume Groups (VGs). The VGs are configured with hypervisor attachments. The administrator executes a Planned Failover to migrate the SQL Cluster to the Recovery Site.
The Failover task completes successfully, but the database administrators report that the database is offline.
What is the possible cause of this issue?

QUESTION 21
Which log file should an administrator review to ensure consistent connectivity stability between primary and remote disaster recovery sites?

QUESTION 22
The Disaster Recovery dashboard in Prism Central shows that the protection domain is out of sync and new recovery points are no longer being created at the recovery site. No recent changes were made to the protection policy configuration or RPO settings.
During initial troubleshooting, an administrator has observed the following:
Production VMs are running normally at the primary site.
The recovery cluster is reachable from Prism Central.
No storage capacity alerts are seen on either cluster.
A recent network change was implemented to enable network segmentation between clusters.
New firewall rules were introduced recently as part of a security hardening effort.
Which action should the administrator take first when evaluating this issue?

QUESTION 23
An organization is implementing a Disaster Recovery solution to protect critical workloads by failing them over to a NC2-on-Azure cluster.
The NC2 environment utilizes Flow Virtual Networking (FVN) for overlay networking. The administrator needs to ensure that when VMs failover to Azure, their IP addresses are predictable and consistent with the application requirements.
Which configuration strategy should the administrator use in the Recovery Plan to achieve predictable IP assignment for the recovered VMs?

QUESTION 24
An administrator needs to provide the QA team with a VM state from four days ago to test an older browser version. However, the current production VM contains new application code and security patches that must not be deleted or overwritten.
Which restore operation should the administrator perform to meet this requirement?

QUESTION 25
An administrator plans on performing a failover of a VM from a source cluster to a DR cluster. The administrator needs the VM’s IP address preserved after failover.
In what scenario is the VM’s IP address preserved?

QUESTION 26
An administrator needs to provide leadership with a report showing the timeframe of each step during Recovery Plan failover testing.
How should the administrator produce this report?

QUESTION 27
An administrator has VMs in a container named VMData on Cluster A that need to be replicated to Cluster B. In order to configure new replications to Cluster B, the administrator creates a container named VMData on Cluster B with an advertised capacity of 200GB.
The VMs on Cluster A in the VMData container have these characteristics:
Large VMs taking up 4TB of space
Low data churn rate
100GB of recovery points
NGT is installed
Recovery points are application-consistent
After replications begin the administrator quickly notices replications are not progressing.
What best explains what happened?

QUESTION 28
A mission-critical VM utilizing an NVIDIA vGPU profile for high-end graphical processing is replicated from a primary Nutanix cluster to a secondary disaster recovery site. After failover of a VM using an NVIDIA vGPU profile, the VM boots but hardware acceleration does not function.
What action is required?

QUESTION 29
A VM is protected in an Async Protection Policy and added to a Recovery Plan. An administrator is attempting to perform a planned failover of the VM.
How many recovery points are created and replicated during the planned failover process?

QUESTION 30
An administrator plans to migrate guest VMs from a legacy Protection Domain-based DR plan to the Prism Central-based Disaster Recovery solution.
What should be done first before removing the legacy protection domains?

QUESTION 31
How does the system behave if the network cannot sustain the data change rate required to maintain a 1-minute RPO between the primary and recovery AZs?

QUESTION 32
Which port needs to be opened between two Prism Centrals to ensure a successful AZ pairing?

QUESTION 33
An administrator logs into Prism Central (PC) and notices that a replication of a recovery point is still ongoing from Cluster A to Cluster B on a new setup.
The bytes being replicated aren’t changing.
Both site’s virtual IP addresses are reachable.
Connectivity between PC/PE is good.
There is a dedicated LAN between the clusters.
What could be causing this replication to be stuck?

QUESTION 34
What is the bandwidth limit of a single Nutanix Cloud Gateway for IPSec traffic?

QUESTION 35
An administrator notices that the link between the source and destination clusters gets overutilized during recovery point replication. The company secured a new 10G connection between the two clusters.
What configuration should the administrator use so that the replication traffic uses the new 10G link?

QUESTION 36
An organization uses Nutanix Disaster Recovery with automatic virtual network creation in the Nutanix Cloud AZ.
After a successful failback operation from the Nutanix Cloud AZ to the on-premises site, what is the expected behavior regarding the dynamically created virtual networks at the recovery site?

QUESTION 37
After an unplanned outage, all VMs were successfully failed over to the recovery site, and users are now accessing workloads from there. The DR dashboard shows the failover is complete and replication from the original primary site has stopped.
As part of post-failover cleanup, what is the most appropriate next action to ensure the DR configuration reflects the current production state and is ready for future protection?

QUESTION 38
During routine monitoring, an administrator notices that replication from the primary Nutanix cluster to the recovery cluster has stopped. New recovery points are not being created, and the DR dashboard shows replication errors.
Investigation reveals:
The primary and recovery clusters are both online and healthy.
Network segmentation was recently enabled to isolate replication traffic from other workloads.
No recent changes were made to firewall rules, protection policies or RPO settings.
Which action should the administrator take first to investigate the replication failure?

QUESTION 39
A company is recovering a 3-tier application (Database, Middleware, Web). The administrator executes the Recovery Plan. The Web tier VMs start up but applications immediately crash because they cannot connect to the Database tier.
Which setting in the Recovery Plan should the administrator have configured to prevent this execution failure?

QUESTION 40
A Nutanix protection policy is configured with:
RPO: 1 hour
Retention period: 5 days
Retention type: Roll-up
After six days of continuous operation, approximately how many hourly recovery points will still be available for restores for the most recent 24-hour period?

QUESTION 41
An administrator initiates an unplanned failover due to a primary AZ outage.
What is the worst-case scenario for data loss and which recovery point will be used by default?

QUESTION 42
A VM is configured with a 5-minute Nearsync RPO. After several hours, replication transitions back to hourly RPO. Alerts indicate the minute schedule cannot be maintained.
What is the most likely root cause?