100% Updated NACE NACE-CIP2-001 Enterprise PDF Dumps [Q10-Q34]

Q10. NACE Standards include:

Q11. Which is used to calibrate a pH meter?

Q12. When measuring the Dry Film Thickness Of liquid coatings applied to galvanized ferrous substrates the most commonly used instrument is the:

Q13. When completing the Final Inspection report the Inspector should write the report using:

Q14. Thermal Spray coatings provide:

Q15. NACE/SSPC Water Jetting standards are directly equivalent to ISO Abrasive Blast Standards:

Q16. Individuals conducting Coating Surveys should:

Q17. Pre-cleaning of work pieces will NOT remove

Q18. The number of air turns in an enclosure can be affected by all of these EXCEPT

Q19. You are the NACY Coating Inspector on a tank lining project where desiccant dehumidification is being used. Since the first shift of abrasive blasting your readings have indicated relative humidity below 40%; however on the second shift of coating application your readings are indicting 80%.
Your FIRST preferred course of action is to:

Q20. Non-Conformance Reports are designed to:

Q21. When performing testing in accordance with ASTM D 2583 the inspector may observe:

Q22. WJ-1 is always performed using UHWJ at pressures above 210 MPa (30,000 PSI)

Q23. You are the NACE Level 2 inspector reviewing the documentation from a NACE Level 1 you notice significant documentation errors.
Your FIRST preferred course of action is to:

Q24. NACE Level 2 Inspectors have been authorized to perform:

Q25. When environmental enclosures are being used an inspector needs to be concerned about:

Q26. You are the NACE Coating Inspector on a tank lining project and are asked to perform a high voltage holiday test after the coating applicators have completed their final repairs. After meeting all the confined space entry permit you enter the tank and notice a very strong odor of solvent.
Your first course of action should to:

Q27. When performing inspection in accordance with ASTM D 4138 the Inspector will use:

Q28. The standards defining surface cleanliness achieved by centrifugal blast cleaning are:

Q29. You are the NACE Inspector on a project where a stationary floating structure is being coated and you notice a self-smoothing anti-fouling coating has been specified.
This is not a good choice because:

Q30. As a NACE Level 2 Inspector, NACE clearly indicates that you ate qualified to independently produce final documentation for a shop project.

Q31. Inspectors perform tests on linings that they may not perform on exterior coatings because

Q32. Coating surveys may include which steps?
Select All That Apply:

Q33. In the event of a conflict between the Product Data Sheet and the Specification:

Q34. The most likely area of failure on a buried external pipeline coating is the: