[Q96-Q118] The D-PCM-DY-23 PDF Dumps Greatest for the EMC Exam Study Guide!

QUESTION 96
A Dell EMC N3048P with two power supplies is configured for Class-Based Power Management.
The switch has the following devices connected and fully operational:
10x 802.3af PDs negotiating as Class0 devices
10x 802.3af PDs negotiating as Class4 devices
10x 802.3at PDs negotiating as Class4 devices
How much power is reserved from the PSE budget by the devices referenced above?

QUESTION 97
What is needed to allow an SSH connection to a Dell EMC N-Series switch?

QUESTION 98
A network administrator added a new Dell EMC N-Series switch into their network with RSTP configured. The spanning-tree priority on all existing switches has been left at the default value.
If the administrator wants this new switch to become the spanning tree root, which command should be used?

QUESTION 99
Which command shows IPv6 adjacent devices on Dell OS6?

QUESTION 100
What is the recommended maximum number of routers, per area, when using OSPF?

QUESTION 101
Which is a valid link-local IPv6 address?

QUESTION 102
A user connects via serial to a switch in a stack and gets the following message: “CLI-Unavailable” What is the likely reason for this message?

QUESTION 103
Which configuration tool will allow a network administrator to override routing protocol decisions and determine the forwarding of packets?

QUESTION 104
A network administrator is configuring a switch for authentication using a RADIUS server.

Based on the graphic, what is incorrectly configured?

QUESTION 105
What is the size of the 802.1Q header of a VLAN-tagged Ethernet frame?

QUESTION 106
What describes Layer 3 QoS?

QUESTION 107
A network administrator configured two Dell EMC N-Series switches with a 2-port port-channel as shown in the graphic.

Based on the configuration, will Host 1 be able to communicate with Host 2?

QUESTION 108
Which RSTP-PV features are embedded and cannot be disabled?

QUESTION 109
What is the base configuration of an interface connected to a VoIP phone?

QUESTION 110
A network administrator wants different applications’ traffic to take different network paths.
Which information can the administrator use to create a match to differentiate the application traffic when using policy-based routing?

QUESTION 111
When configuring a PBR route-map, what are the configurable “SET” options?

QUESTION 112
Which OSPF packet type is sent to the neighbor when LSDB difference is detected?

QUESTION 113
What is the default login authentication method used for console access?

QUESTION 114
What is the typical sequence of steps to upgrade the firmware of a Dell EMC N-Series switch?

QUESTION 115
In a Dell EMC Campus networking environment, what are the valid port states for RSTP?

QUESTION 116
In the VRRP configuration between two switches, switch A is configured with priority 150 and switch B with priority 100.
Which configuration is valid to trigger fail over if the tracked interface on the Primary unit is down?

QUESTION 117
Which type of an attack is considered MAC poisoning?

QUESTION 118
If a user’s IP phone sends a frame to a Dell EMC N-Series switch with a dot1p value of 5 in the frame header, what will the switch do to this frame by default?