2022 Latest HPE2-W09 DUMPS Q&As with Explanations Verified & Correct Answers [Q26-Q41]

Q26. Does this correctly describe routing information advertised by a VXLAN Tunnel Endpomt (VTEP) that uses EVPN?
Solution: MAC/IP advertisement routes advertise the MAC addresses that can be reached through the VTEP.

Q27. You are configuring Ethernet Ring Protection Switching (ERPS) on an ArubaOS-CX switch. Is this a guideline for configuring timers?
Solution: The guard interval is set in units of seconds and is used to prevent frequent topology changes due to a link going up and down.

Q28. Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching IERPS) solution?
Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site.

Q29. Refer to the exhibits.


Is this how the switch-1 handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN 10, except the incoming interface. It encapsulates the broadcast with VXIAN and sends it to 192.168.1.3, out not 192.168.1.2.

Q30. Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Combine multiple links between two data centers into link aggregations (but not multi-chassis ones).

Q31. Refer to the exhibit.

You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN) WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be part of the same VXLANs and the desired VNls for the VXLANs. Assume that the network is already configured to permit each ArubaOS-CX switch to reach each other switch’s loopback interface.
Is this part of the process for setting up VXLAN to meet the requirements?
Solution: On Switch-1, set 192.168.1.3 as a peer IP address in the VNI 5020 context.

Q32. You are using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard config to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Inside a configuration plan, light-click any device-specific parameters and modify the parameter per-device.

Q33. AtubaOS-CX switches are acting as Virtual Extensible LAN (VXLAN) Tunnel Endpoints (VTEPs) WITHOUT Ethernet VPN (EVPN).
Does this correctly describe how the VTEPs handle VXLAN traffic forwarding?
Solution: VTEPs that use headend replication forward unicasts with unknown destination MAC addresses as unicast packets to each VTEP in the same VNl.

Q34. You ate using NetEdit to manage AruDaOS-CX switches. You want to deploy a standard conflg to the switches, but need the config to include a few device-specific settings such as hostname and IP address.
Is this what you should do?
Solution: Instead of using a standard configuration plan to deploy the configuration, create an auto config plan that uses scripts.

Q35. Does this correctly describe NetEdit’s notification capabilities?
Solution: NetEdit notifies admins of errors using Its Internal email server.

Q36. Refer to the exhibit.

The company wants AtubaOS-CX switches to provide VXLAN services for several VMs and servers, as shown in the exhibit. Hypervisors will not run VXLAN for this solution. Is this part of a valid configuration to meet the requirements?
Solution: Work with the server admins to assign a consistent VLAN for VMs 1 and 4. Assign interface 1/1/2 on Switch-1 to the same VLAN.

Q37. Is this something that NetEdit 2.0 does after it discovers a switch?
Solution: It enables the switch REST API Interface, if disabled.

Q38. Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?
Solution: extending Layer 2 communications between data centers that connect over Layer 3 MPLS links

Q39. Refer to the exhibit.

which shows the topology tot an Ethernet Ring Protection Switching (ERPS) solution.
Is this a valid design for the control and protected VLANs on the VSX fabric 1 switches?
Solution: Ring l, instance 1:
control VLAN: 1000 protected VLANs: 51-135 Ring 1, Instance 2:
control VLAN: 1000 protected VLANs: 136-220 Ring 2, Instance 1: control VLAN: 1001 protected VLANs: 181 -200 Ring 2, Instance 2: control VLAN: 1001 protected VLANs: 201 -220

Q40. Is this a best practice when positioning ArubaOS-CX switches in data center networks?
Solution: Deploy Aruba CX 6300 switches as data center spine switches.

Q41. A data center has a three-tier topology with ArubaOS-CX switches at each layer, is this a use case for implementing Virtual Switching Extension (VSX) at the core?
Solution: The aggregation layer operates at Layer 2 only, and the core provides Layer 2 and Layer 3 functions.