H35-480_V3.0 Exam Questions Dumps, Selling Huawei Products [Q21-Q40]

QUESTION 21
What is the maximum MIMO mode supported by Huawei 5G indoor CPE?

QUESTION 22
Which of the following methods can be used by a gNodeB to obtain downlink channel characteristics? (Choose All that Apply)

QUESTION 23
According to 3GPP specifications, which of the following is not an RRC state in 5G?

QUESTION 24
What are the typical sizes of ping packets and intervals in single site verification?

QUESTION 25
Which of the following RF modules support 64T64R? (Choose All that Apply)

QUESTION 26
Which downlink data split modes are supported on the gNodeB side in the 5G NSA Option 3x architecture? (Choose All that Apply)

QUESTION 27
Which of the following is the correct sequence for adding gNodeB hardware?

QUESTION 28
The mmWave range is new for NR. It supports the largest bandwidth in a cell but has poor coverage capabilities.It requires high performance from RF components and generally applies only to line of sight (LOS) coverage.

QUESTION 29
5G wireless network cloudification can significantly improve the user rate.

QUESTION 30
Which of the following parameters is related to the frequency-domain position of PBCH DMRSs?

QUESTION 31
If the length of the CPRI optical fiber between a BBU and an RRU exceeds 150 m, you are advised to use a multimode fiber.

QUESTION 32
During a 5G test, a portable computer is directly connected to the LAN port of the Huawei CPE through a network cable to obtain a dynamic IP address for communication.

QUESTION 33
If multiple IP addresses are planned for a gNodeB and the next-hop IP addresses are different, which of the following route configurations is more suitable?

QUESTION 34
5G wireless network cloudification can significantly improve the user rate.

QUESTION 35
The purpose of replaying logfiles is to reproduce the test process. The GENEX Probe can work without license in this case.

QUESTION 36
Which of the following devices is used to implement service slicing on the 5G RAN side?

QUESTION 37
Which of the following frequency locking modes is not supported when the GENEX Probe is used to perform a CPE test?

QUESTION 38
E2E network device update is required for the evolution from 5G NSA networking to SA networking.

QUESTION 39
The RSRP value of the test terminal can be viewed on the GENEX Probe. Which of the following test results indicate good signal quality?

QUESTION 40
Which of the following functions are implemented by the UBBP board in the BBU5900?