HP New 2022 HPE2-W09 Sample Questions Reliable HPE2-W09 Test Engine [Q22-Q42]

NO.22 Is this something that NetEdit 2.0 does after it discovers a switch?
Solution: It enables the switch REST API Interface, if disabled.

NO.23 Is this something that NetEdit 2.0 does after it discovers a switch?

NO.24 Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Implement Virtual Switching Extension (VSX) on pairs of ERPS switches at the same site. Then combine multiple links between two data centers into VSX LAGs (M-LAGs).

NO.25 Refer to the exhibit.

Switch-1, Switch-2, and the router run OSPF on LAG 100, which is a Layer 3 LAG. Does this correctly explain how to control how core-to-access traffic Is forwarded?
Solution: To reduce the amount of traffic sent over the ISI between Switch-1 and Swltch-2. enable active forwarding on LAG 100 on both Switch-1 and Switch-2.

NO.26 Refer to the exhibits.


Is this how the switch-1 handles the traffic?
Solution: A broadcast arrives in VLAN 10 on Switch-1. Switch 1 forwards the frame on all interfaces assigned to VLAN10. except the incoming interface. It replicates the broadcast, encapsulates each broadcast with VXLAN. and sends the VXLAN traffic to 192.168.1.2 and 192.168.1.3.

NO.27 Refer to the exhibit.

The company wants AtubaOS-CX switches to provide VXLAN services for several VMs and servers, as shown in the exhibit. Hypervisors will not run VXLAN for this solution. Is this part of a valid configuration to meet the requirements?
Solution: Attach VNIs 5010 and 5020 to interface 1/1/3 on Switch-2.

NO.28 Is this part of a valid strategy for load sharing traffic across the links in an Ethernet Ring Protection Switching (ERPS) ring?
Solution: Combine multiple links between two data centers into link aggregations (but not multi-chassis ones).

NO.29 You need to integrate Aruba Fabric Composer (AFC) with customer datacenter software. Is this integration possible?
Solution: Aruba Fabric Composer (AFC) with Nutanix Hypervisor (AHV)

NO.30 A customer’s servers use ISCSI, and they send data and storage traffic on the same pair of I OGbE links. Is this a best practice for supporting the ISCSI requirements?
Solution: Set up dedicated switches to connect to iSCSl arrays. Connect top of rack (ToR) switches, which will support both data and storage traffic, to those dedicated switches.

NO.31 Is this a use case for implementing Enhanced Transmission Selection (ETS) on an ArubaOS-CX switch?
Solution: to help the switch to look inside tunneled traffic and apply different quality of service (QoS) settings to different types of traffic

NO.32 Your task is to configure an EVPN solution for a dual-stack IPv4 and IPv6 protocol in the overlay networks. Is this statement about EVPN and IPv6 correct?
Solution: Different virtual MAC must be used for IPv4 and IPv6 Active Gateway.

NO.33 Refer to the exhibit.
Refer to the exhibit.

You are adding a VLAN 30, subnet 10.0.30.0/24 to the network shown in the exhibit. (This network is simplified to just the relevant switches for this item.) This subnet belongs in VRF A, and you have added a Layer 3 VLAN 30 interface attached to this VRF on Switch-1. You want to make the services in this VLAN available to devices in 10.1.20.0/24 in VRF B.
Is this part of a valid setup for meeting these requirements?
Solution: Add VRF B as the secondary VRF on VLAN interface 30.

NO.34 You enter this command on an ArubaOS-CX switch:
Switch# show erps status ring 1
Is this what the specified status means?
Solution: The status is Protection, which means that the ring is up and fully connected with the RPL port blocked.

NO.35 Is this correct positioning of AtubaOS-CX switches in the data center?
Solution: Aruba CX 8325 switches are an appropriate choice for leaf switches in a leaf-spine topology that uses Virtual Extensible LAN (VXLAN) with Ethernet VPN (EVPN).

NO.36 Refer to the exhibit.

which shows the topology tot an Ethernet Ring Protection Switching (ERPS) solution.
Is this a valid design for the control and protected VLANs on the VSX fabric 1 switches?
Solution: Ring 1, instance 1:
control VLAN: 1000protected VLANs: 51-135 Ring l,Instance2:
control VLAN: 1001 protected VLANs: 136-220 Ring 2, Instance 1: control VLAN: 1000 protected VLANs: 181 -200 Ring 2, Instance 2: control VLAN: 1003 protected VLANs: 201 -220

NO.37 Is this a use case for deploying Ethernet Ring Protection Switching (ERPS)?
Solution: extending Layer 2 communications between data centers that connect over Layer 3 MPLS links

NO.38 Refer to the exhibit.

You want to enable devices in VRF B and VRF C to reach shared resources in VRFA.
is this a valid strategy for meeting this goal?
Solution: Create a separate OSPF process for each VRF on Switch-1. Then redistribute each process into the other VRFs’ processes.

NO.39 You plan to use multi-protocol BGP to implement dynamic VRF route leaking on an ArubaOS-CX switch.
Is this a rule for the setup?
Solution: You cannot leak multicast routes.

NO.40 Is this how you should position switches in the ArubaOS-CX portfolio tor data center networks?
Solution: Deploy Aruba 83xx switches as data center leaf switches.

NO.41 Refer to the exhibit.

You need to set up an ArubaOS-CX switch to implement Virtual Extensible LAN (VXLAN) WITHOUT Ethernet VPN (EVPN). The exhibit Indicates which servers should be part of the same VXLANs and the desired VNls for the VXLANs. Assume that the network is already configured to permit each ArubaOS-CX switch to reach each other switch’s loopback interface.
Is this part of the process for setting up VXLAN to meet the requirements?
Solution: On Switch-1, set 192.168.1.3 as a peer IP address in the VNI 5020 context.

NO.42 Does this correctly describe the ArubaOS-CX architecture?
Solution: The ArubaOS-CX time-series database helps to support network analytics and troubleshooting.