[Feb-2022] Feel Cisco 300-610 Dumps PDF Will likely be The best Option [Q30-Q54]

NO.30 Refer to the exhibit.

What must be the default gateway of the servers in EPG Web?

NO.31 Drag the appropriate from the left onto the current UDLD modes of operation on the right.

NO.32 An engineer must interconnect two geographically separated data centers. The service provider offers a Layer 2 Metro Ethernet link. The strict security policy requires that the information that is shared between two sites must be sent encrypted. The application deployed between two sites requires a line-rate throughput regardless of the packet size and speed.
Which solution meets these requirements?

NO.33 A company has several data centers with hundreds of Cisco UCS blade chassis. A network consultant plans to active Cisco Discovery Protocol to the servers to facilitate Layer 1 troubleshooting. For security reasons, the company wants to restrict the servers from sending different MAC addresses to the fabric interconnect after the MAC address from the first packet is learned. Which two policies be modified to support this design? (Choose two.)

NO.34 An engineer must build a VXLAN flood-and-learned network. The customer requires the solution to be based on the IETF documented practice in RFC 7348. The solution must use broadcast, unknown unicast, and multicast (BUM) and include the efficient BUM and short BUM replication modes that use only shared trees. Which technology meets these requirements?

NO.35 Drag the requirements from the left onto the correct policy types on the right.

NO.36 Which multicast rendezvous point redundancy mode is valid for Bidirectional PIM?

NO.37 An engineer must configure an interface for managing and orchestrating a Cisco Nexus device. The interface must be operational if the data and control planes crash, support IPv4 and IPv6 addressing, and have access to its own VRF instance.
Which interface should be used to meet these requirements?

NO.38 Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.

NO.39 DRAG DROP
Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.
Select and Place:

NO.40 Which two types of service profile templates does Cisco UCS support? (Choose two.)

NO.41 A customer must install a new Hyperflex Stretched cluster in two sites. Low latency and predictable high performance are the top priorities for this setup due to the extensive usage of data-intensive applications across the cluster. Which HyperFlex storage solution is recommended to meet these requirements?

NO.42 An engineer must design a multitenant solution using Cisco 7709 switches. The solution must support separate routing instances, separate spanning tree domains, and separate firewalls for each tenant.
Which solution meets these requirements?

NO.43 Drag and drop the configurations from the left onto the correct policies on the right.

NO.44 Drag and drop the components from the left onto the descriptions on the right that indicate what occurs to Fibre Channel fabric when that component fails.

NO.45 Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.

NO.46 Drag and drop the SAN components from the left onto the correct design considerations on the right.

NO.47 Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.

NO.48 An engineer is designing a Multichassis EtherChannel topology in which two switches must appear as a single device to a third downstream switch? Which two technologies meet this requirement? (Choose two.)

NO.49 An engineer is expanding an existing ISCSI environment and must choose an addressing scheme. When checking one of the devices, the engineer discovers this target device naming used
{prefix}. 2019-01.com.acme.123:00. ftd0cb21.bcb389458389
Which addressing scheme was used in the environment?

NO.50 Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.

NO.51 Drag and drop the Cisco Nexus 7000 Series Switch resources from the left onto the correct groups on the right.

NO.52 Drag and drop the feature descriptions from the left onto the correct UCS Fabric Interconnect modes on the right.

NO.53 An engineer configured the OSPF protocol in the vPC topology. During the catastrophic failure of one of the vPC the member switches, the traffic was routed to a black hole. This route was caused by the long convergence time caused by the delay of the of the vPC member switch reboot. After the failure, the engineer rebooted both switches, but the secondary switch powered on before the primary one. It caused all the vPCs to be shut down due to consistency-check violations. Which two features must be used to prevent these situations from happening in the future? (Choose two.)

NO.54 A customer asks an engineer to develop a framework to configure Cisco services that will be used to replace process of manual device configuration. The engineer plans to use a programmatic interface and must keep these considerations in mind:
* The customer’s environment requires the script to authenticate before executing further actions.
* The customer’s security requirements mandate the use of HTTPS transport.
* The support stall has limited shell scripting knowledge, so the scripts should be easy to read and write and be serf-documenting.
Which two solutions should be used to meet these requirements? (Choose two.)