300-510 Dumps To Pass Cisco Exam in 24 Hours – BraindumpsPass [Q55-Q74]

NEW QUESTION 55
Which statement about BFD on Cisco IOS XR Software is true?

NEW QUESTION 56
What are three requirements for a static IPv6-in-IPv4 tunnel? (Choose three.)

NEW QUESTION 57
A network engineer is troubleshooting OSPF multiarea. Which Cisco IOS XR feature should the engineer use in order to streamline OSPF issue?

NEW QUESTION 58
Which statement about BFD on Cisco IOS XR Software is true?

NEW QUESTION 59
Refer to the exhibit. XR1 and XR2 are sending the prefix 10.11.11.0/24 to XR3.
A configured policy on XR1 is incorrectly prepending AS path 11 11 12 12 onto this prefix.
A network operator wants to add a policy onto XR3 that will not allow the falsely prepending prefix from being installed.
Which policy configuration applied to the XR3 neighbor configuration for XR1 can accomplish this requirement without impact to other or future received routes?

NEW QUESTION 60
Refer to the exhibit.

Refer to the exhibit. An engineer is troubleshooting an issue with this network and notices that prefixes from R3 are missing on the R1 routing table Due to repeated ASN when the 10 0 0 0’8 prefix from R3 arrives at R1, BGP automatically rejects it There is no prefix-list on R1 which blocks the traffic from R3 What should the engineer do to fix the problem so that BGP allows that prefix on R1?

NEW QUESTION 61
Refer to the exhibit.

Routers R1, R2. R3, and R4 have been configured to run OSPF. and router R5 is running EIGRP Traffic from R1 to R5 is expected to pass via R4. but OSPF routing has calculated the best path via R3. Which action corrects the problem?

NEW QUESTION 62
Refer to the exhibit.

Routers R1 and R2 cannot form a neighbor relationship, but the network is otherwise configured correctly and operating normally. Which two statements describe the problem? (Choose two.)

NEW QUESTION 63
Refer to the exhibit.

A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?

NEW QUESTION 64
Refer to the exhibits.

All links inside the network are configured at a default cost of one inside the fully converged OSPF domain. Given the configuration from XR1, which interface does traffic from XR1 that is destined to the loopback interface of XR6 select for the exiting interface?

NEW QUESTION 65
Refer to the exhibit.

Which two commands must the engineer configure for the company’s PIM-PIM network to enable Auto-RP mappings to be sent over the FastEthernet0/0 interface without affecting normal operation? (Choose two)

NEW QUESTION 66
Refer to the exhibit. Routers R1 and R2 reside in AS 65530, which is multihomed to the Internet.
A network engineer expects devices in the AS to use R2 to access the Internet, but they are using R1 as the exit point from the AS. Which action corrects the problem?

NEW QUESTION 67
Refer to the exhibit. VPN users that are connected to PE routers are facing network issues.
Traffic that originates from CE1 drops before reaching CE2. An engineer finds no outgoing traffic statistics on PE1 and PE2 routers toward CE devices and finds that the PE1 router is running the older software image. Which action must be implemented to resolve the issues?

NEW QUESTION 68
Refer to the exhibit.

Routers RA and RB are IS-IS peers configured for NSF but router RC is an IS-IS peer without NSF capability If RA undergoes processor switchover what is the effect on the network environment?

NEW QUESTION 69
Refer to the exhibit. After configuring IS-IS on routers R1 and R2, an engineer notices that only the loopback interface at 2000:1::1 /96 is known to router R2. Which change must be made so that only Loopback2 is advertised from R1 to R2?

NEW QUESTION 70
Refer to the exhibit.

Refer to the exhibit. Excessive routes are flooding from network 150.0.0.0 into AS100. Internet traffic between AS400 and AS300 is working normally. No route controlling mechanism is applied on incoming and outgoing traffic Which configuration resolves the issue?

NEW QUESTION 71
Refer to the exhibit. A network operator is getting the route for 10.11.11 0/24 from two upstream providers on #XR3.
The network operator must configure #XR3 to force the 10.11.11.0/24 prefix to route via next hop of 10.0.0.9 as primary when available.
Which of these can the operator use the routing policy language for, to enforce this traffic forwarding path?

NEW QUESTION 72
Refer to the exhibit.

A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?

NEW QUESTION 73
Which command is used to enable BIDIR-PIM under global configuration mode for Cisco IOS XE Software?

NEW QUESTION 74
Refer to the exhibit. CE1 and CE2 are iBGP neighbors in AS 65516. All traffic that exits AS 65516 must use the link from CE1 to PE1. CE1 is advertising a higher local preference to CE2, but traffic from CE2 still prefers the PE2 link. Which action corrects the problem?