JN0-280 Practice Exam and Study Guides – Verified By BraindumpsPass Updated 187 Questions [Q103-Q120]

NEW QUESTION 103
Which two statements about IBGP are correct? (Choose two.)

NEW QUESTION 104
By default, which two statements are correct about BGP advertisements? (Choose two.)

NEW QUESTION 105
Which OSPF troubleshooting tool is used to check the OSPF process and neighborship?

NEW QUESTION 106
What information in the Ethernet header is used to populate the bridging table?

NEW QUESTION 107
Which of the following BGP attributes is considered first in the route selection process?

NEW QUESTION 108
Which Junos OS routing table stores IPv6 addresses?

NEW QUESTION 109
What is the primary use of a virtual link in OSPF?

NEW QUESTION 110
Exhibit:

How many stages are shown in the exhibit?

NEW QUESTION 111
Which two statements are correct about using LACP on a Junos device? (Choose two.)

NEW QUESTION 112
You want to enable a Junos device to support aggregated Ethernet interfaces. In this scenario, which configuration hierarchy would you use?

NEW QUESTION 113
Which statement is correct about the OSPF link-state database?

NEW QUESTION 114
Which statement is correct about member interfaces when creating a LAG?

NEW QUESTION 115
EVPN/VXLAN is primarily used in modern data centers to:

NEW QUESTION 116
What is an aggregate route?

NEW QUESTION 117
Which VLAN tagging method inserts a 4-byte tag into the Ethernet frame?

NEW QUESTION 118
Within your router, you want to verify that you are learning routes from a remote BGP peer at IP address
10.10.100.1. Which command would satisfy the requirement?

NEW QUESTION 119
Generated routes in a network are mainly used to:

NEW QUESTION 120
What are two device roles in a five-member Virtual Chassis? (Choose two.)