2023 Latest 100% Exam Passing Ratio – H35-480_V3.0 Dumps PDF [Q21-Q35]

NEW QUESTION 21
Which of the following RF modules support 64T64R?

NEW QUESTION 22
If multiple IP addresses are planned for a gNodeB and the next-hop IP addresses are different, which of the following route configurations is more suitable?

NEW QUESTION 23
Which of the following messages is the first message sent by a gNodeB to an AMF?

NEW QUESTION 24
What are the typical sizes of ping packets and intervals in single site verification? (Choose All that Apply)

NEW QUESTION 25
The purpose of replaying logfiles is to reproduce the test process. The GENEX Probe can work without license in this case.

NEW QUESTION 26
Which of the following channels (signals) can be used for cell measurement in NR?

NEW QUESTION 27
What is the maximum number of PCIs supported by a 5G network?

NEW QUESTION 28
Which of the following is the correct sequence for adding gNodeB hardware?

NEW QUESTION 29
During 5G single site verification, you only need to test the user access and rate. Other test items are analyzed in drive tests.

NEW QUESTION 30
C-band is the most popular frequency band for 5G network deployment. However, there is an imbalance between uplink and downlink coverage – how much does this imbalance approximately amount to?

NEW QUESTION 31
At which layer is downlink data split implemented over the NR air interface in the NSA Option 3x architecture?

NEW QUESTION 32
Which of the following can be used to check whether an antenna is reversely connected during NR single site verification?

NEW QUESTION 33
Which of the following NR slot configurations are defined in 3GPP specifications? (Choose All that Apply)

NEW QUESTION 34
During 5G single site verification, you only need to test the user access and rate. Other test items are analyzed in drive tests.

NEW QUESTION 35
Which of the following frequency locking modes is not supported when the GENEX Probe is used to perform a CPE test?